DICOM Configuration
From MedITEX - Wiki
(Difference between revisions)
| Line 1: | Line 1: | ||
| − | + | <p>In System settings, under DICOM Configuration, the following three services must be entered:</p> | |
| + | <ul> | ||
| + | <li>STORE</li> | ||
| + | <li>STR.REPORT</li> | ||
| + | <li>WORKLIST</li> | ||
| + | </ul> | ||
| + | <p>The IP Address that should be used is the IP Address of the server where MedITEX DIOCM Server is installed.</p> | ||
| + | <p>The port has to be <strong>108 </strong>(previously configured for MedITEX DICOM).</p> | ||
| + | <p>After the configuraion is done, it is possible to check the connectivity of each entered service by selecting the specific service and clicking on "<strong>Test Connection</strong>".</p> | ||
| + | <table style="margin-left: auto; margin-right: auto;" border="0"> | ||
| + | <tbody> | ||
| + | <tr> | ||
| + | <td> </td> | ||
| + | </tr> | ||
| + | </tbody> | ||
| + | </table> | ||
Revision as of 09:23, 22 September 2017
In System settings, under DICOM Configuration, the following three services must be entered:
- STORE
- STR.REPORT
- WORKLIST
The IP Address that should be used is the IP Address of the server where MedITEX DIOCM Server is installed.
The port has to be 108 (previously configured for MedITEX DICOM).
After the configuraion is done, it is possible to check the connectivity of each entered service by selecting the specific service and clicking on "Test Connection".